Notes

A sinew cable-backed bow.Source of the information below: Inuvialuit Pitqusiit Inuuniarutait: Inuvialuit Living History, The MacFarlane Collection website, by the Inuvialuit Cultural Resource Centre (ICRC), Inuvik, N.W.T., Canada (website credits here http://www.inuvialuitlivinghistory.ca/posts/12 ), entry on this artifact http://www.inuvialuitlivinghistory.ca/items/104 , retrieved 1-8-2020: Sinew-backed recurve bow made from a single piece of wood, probably spruce. The bow stave is elliptical in cross section along its entire length and flares outward slightly between the grip at the midpoint and the ends when viewed from the front and back. It has knob-like projections at each end for holding the bowstring, which is of braided sinew. The braided sinew backing is attached to sinew lashings that pass under the backing cables and encircle the stave. A piece of hide has been laid between the backing and the stave. More information here: http://www.inuvialuitlivinghistory.ca/item_types/9: Bows with sinew backing were one of the most sophisticated hunting weapons of the Inuvialuit. The bow stave was often made from a single piece of spruce somewhat more than a metre in length, with a continuous piece of braided sinew laid along the back of the stave in several strands that wrapped around each end. The sinew strands were attached to the stave near each end with a series of hitches, and between these hitches the strands were twisted into two tight cables. The sinew backing added strength and elasticity to the bow. There were two main types of these bows. Simple bows when strung curve in an arc from one end to another. They were often used when hunting small animals and birds. Recurve bows are constructed so that the centre of the strung bow curves towards the archer then bends away at each end. The recurve shape together with the sinew backing made this type of bow a powerful tool for hunting large animals. Bowstrings were made from braided sinew.