Carving of an ivory coloured fish that balances on top of a thin stand (part b). The white fish is slightly curved, with two fins on top, one below; incised circles for the eyes with a point at centre; lines for the gills and mouth. The fish has a hole in the belly that fits over the top of the stand. The darker stand has a somewhat circular base with a vertical post. Unsigned.

Two pronged antler carving attached to a stone base. In the lowest section of the antler a human-like face is carved. Just above where the antler splits in two branches, is a carved water spirit(?) type creature with caribou fur for hair and flippers as hands and feet; at the end of that prong another smaller creature with flippers is carved. The other branch sticks out to the side and has a twist carved into most of its length; at the end is a bird-human type creature, carved as if it is biting the branch with a large beak; its two legs and an arm are extended out. The stone base is irregular, but almost square. Unsigned.

Amulet carved from antler in the shape of a side-facing killer whale, with engraved designs all over the front side. Abalone inlay for eyes, teeth, nostrils and the various ovoid decorations around its body. The back is uncarved and undecorated.

Gift of Meredith and Robert Amon.

Gift of Allan and Lenore Sindler.

Band of bent antler tied together at ends with hide tie. Engraved with repeating pattern of small circles, with a dot in the middle, and two lines underneath each circle. Four drilled holes replace four of the circles.

Band of bent antler, tied together at ends with hide strip. Engraved with repeating pattern of circles, with a dot in the middle, down the centre and straight and diagonal lines carved along the edges. Drilled holes top four of the pairs of lines on one side of the band. Two lines around the band separate the three patterns.

Large band of bent antler tied together at ends with two hide ties. Engraved with repeating pattern of circles, with a dot in the middle, and pairs of lines carved near both edges. Drilled holes top the pairs of lines on one side of the band. Two lines around the outside surface separate the three patterns.