Bag 7a; from Test Pit 3; rusted; fractured near mouth; dent halfway up casing; crack near base

Ulu type knife. Metal blade is crescent-shaped with a beveled bottom edge. Blade held in place by bronze metal plates on both sides, that slot into the underside of the handle. Three copper nails have been hammered through the bronze plate into the blade to hold it in place, with the ends smoothed to blend with the bronze plate. The handle is a rectangular piece of horn, with a curved top edge. A hide cord is tied around centre of handle.

Copper covered plaque, with painted designs on front. Large piece of copper sheeting is wrapped around a board in the shape of a Northwest Coast copper. The front is divided into four sections, with various creatures painted in each; red and black paint used for background and highlights. Copper sheet held in place by upholstry tacks and tape on back; the board is unpainted.

Harpoon (part a) with a detachable head (part b). Harpoon has a cylindrical steel shaft inserted into a wider wooden handle. Ends of wood are capped with copper(?). Hide cord wrapped around bottom end in a loose spiral, before tightening into a thick band; hide acts as a handgrip. Second hide tie knotted around base of metal shaft. Top of shaft tapers to a point, for head to fit on. Harpoon head consists of an oval-shaped blade, with a sharp point, welded to a triangular holder. Long rope line strung through hole drilled into centre of holder, creating a large loop. Rope is secured together at intervals.

Harpoon (part a) with a detachable head (part b). Harpoon has a flat shaft, made of two pieces of antler riveted together, that narrows to a point. Shaft is inserted into a wider “V”-shaped piece of antler, riveted to a cylindrical wooden handle. Knife-shaped, antler blade secured to opposite end of handle with hide ties and copper nails. Hide strip woven through the bottom centre of wooden handle. Strip held close to handle with hide and rope ties. Harpoon head consists of an oval-shaped steel blade, with a sharp point, riveted to a triangular holder. Long hide strap strung through hole drilled into centre of holder. End of strap has a loop handle.

Standing wood shrine figure. Body is rectangular in shape and has geometric and linear motifs incised on the front and sides. Hide collar, coloured black, wrapped around neck. Figure has a wide nose, pronounced brow and lips, and angular eyes. Has a ponytail that protrudes sharply from the back of the head. The end of ponytail connects to the figure's back. Lines incised on portions of hair overtop of head, hanging portion of ponytail is thin and smooth. There is a small gap between the ponytail and the back of the figure’s neck. Extending from all sides of the hide collar are strands of cowrie shells. Long strings of black, red and white glass beads are tied around the ponytail with light brown thread. Two copper coins and one small brass(?) bell are attached to the bead strings, hanging down the back of the figure. Plain brown tie, with knotted ends, is strung between the ponytail and the neck of the figure.

Plain copper pin. Has round, flattened head and tapering shaft. Small hole drilled just above the shaft.

Small, black, cast metal hat with two copper ties.

Horn spoon, the bowl and handle made separately and riveted together by copper rivets, elaborately decorated with conventionalised animals, totemic figures, etc. carved in the round on the handle and engraved on the back of the bowl.; Good

Pair of metal feline-shaped paws, with attached, protruding claws. Some claws missing from each paw; holes show there would have been four across the top and one at the side. There are small attachment holes along the sides of both. Metal is highly corroded to a greenish-blue colour. Textile remnants are adhered to the upper surface of the left paw.