Detachable steel harpoon head with fork-shaped end. The steel is marked "Made in England".

Long dark brown coloured tubular lidded quiver (parts a-b). Both wooden and bamboo arrows (parts c-q) are feathered, and secured with skin and fibre. Quiver (part b) has been lightly tooled with curved line patterns. Arrowhead (part r) goes with arrow (part p).

Hoe with flat, flared metal tip that has one sharp edge and has been inserted into an L-shaped wooden handle. The handle has been burnt to a dark brown colour at both ends, each decorated with of indented circles.

Axe with L-shaped wooden handle and triangular blade with curved blade edge. The handle shaft cuves slightly and the top of the handle is burnt to a dark brown finish. The blade has an incised design on both faces of two zigzag lines joined by short vertical lines.

Cylindrical shaped bell that is cut-out on each side. A long tubular ringer is attached to a ring. The ring is attached to an arched piece that connects the two cut-out sides of the bell.

Tool with a curved, "bill hook" metal blade that comes to a rounded point. The handle has a roughly cylindrical shaft that tapers slightly towards the end where it flares out slightly, and the tip of the handle where the metal blade is inserted flares out slightly and bends diagonally.

Spear point, square in cross section, with a round, hollow shank that has an open seam.

Axe with copper-covered wooden handle with a rounded top and flared butt end, and a steel crescent-shaped blade with three supporting arms. The middle arm of the blade has four faces in low relief. The handle has indented decoration of small dots and two large circles.

Knife with a curved blade that comes to a point at the tip. The wooden handle flares at both ends, and is wrapped in alternating bands of copper and iron wire. The butt end of the wooden handle is covered in a narrow strip of copper.

Long leather case (part a) of wood covered with leather, with a belt band that is five rows thick at one end, and one row thick at the other end. Thinner band fits into hole located at the end of the thick band. Long metal blade (part b) with central ridge and brown rounded handle.