Hand-made adze with a wooden handle made from a tree branch; bark is removed only at the tip and head of handle. The blade fits into carved space and is bound to handle with black-brown twine. A material that appears to be thick cardboard, along with some pieces of wood, is wedged between the blade and the mount. The back of the adze head has a small section of white paint on it.

Small hand-made adze with wooden handle made from a tree branch. Curved, wide, metal blade is attached to wood with black cord covered with green coloured cotton gauze and masking tape. White paint is on back end of handle.

Low-angle block plane is a light touchup plane. It consists of a base and a handle with a blade that is adjusted by a knob located below the handle. The blade is set at an angle of approximately 12 degrees. A set screw on top of the handle holds the blade in place. A lever is located on top of the handle, above the set screw. A screw is located at the front of the plane, in front of the blade. An inscription is molded into the steel at the top front. The top of the base and the handle are painted.

A 3/4 inch #9 straight gaoge with a green and gold maker's label on handle: 'Henry Taylor Tools Sheffield England', and a dark blue mark that may be owner's initials. Tool consists of a metal blade with a finished wood handle. A metal cinch holds wood tight around the blade.

Double-handled knife with long one-sided steel blade in the middle. The drawknife blade is sharpened on lower side only and inserted on either end into solid tear-shaped wooden handles. The sharpened blade is cut out 3 cm from handle.

Rectangular piece of grey coloured skin with four ties attached through horizontal slits along the long sides; rounded corners. Black, green and red paint streaks on the front. Inked on both sides. Some ties are sewn to skin.

Part (a): knife with carved wood handle tapered at both ends. Stamped letters in three rows, 'RK FROST MORA SWEDEN'. Blade inserted in oval-shaped hole at end with groove. Opposite end has metal peg. Part (b): grey manufactured plastic case with tab for attaching to a belt. Word 'Frosts' embossed on front.

Canvas tool holder with a hemmed upper edge; the other three sides are bound with twill tape. There are two pieces of twill on the left side that extend from the object. Covering one third of the holder is a strip of canvas at lower edge, sewn in vertical lines creating twelve, rectangular pockets.

Double-sided curved knife with long wooden handle. The blade is attached to the handle by a cord that is wrapped around handle. The end of the handle has been shaved down and angled at the bottom into a wedge. There is a mark, 'GD' carved into the back of the handle and also drawn in blue ink on the bottom front of the handle.

Double-edge, highly curved pointed blade set in plain wooden handle. Blade set in groove and bound to handle with brown-black cord wrapped around top. Green mark on cord and on handle between blade and cord.